BMS is able to build collars up to Ø 1219 thickness 10 mm, caps up to Ø 273, reductions Concentric and eccentric, branch welded TEE up to a thickness of 12 mm
In addition, 90° and 45°, R=1.5 welded elbows are built from Ø 219 to Ø 609, 10 mm thick, and custom-made parts for such as crosses or virole.
On request, we can perform 100% RX products and heat treatments.
BRANCH WELDED TEE AND BRANCH WELDED REDUCED TEES
WELDED TEE
Manufactured by cold working.
They are made from calendered and welded sheet metal.
They are the result of a joint between a cylinder and a welded branch.
Used in the construction of implants where it is necessary to make a lateral deviation on the main pipeline.
All products are marked
WELDED TEE SPECIFIC
1.4301/1.4307/304/304L
1.4401/1.4404/316/316L
*other materials on request
EN 10253
STAINLESS STEEL
168 – 1219
On request:
RX, penetrant liquids, heat treatment
Fields of application:
Industrial plants, Purification, Oil & Gas, Chemical, Petrochemical, installations for the paper industry
BRANCH WELDED REDUCED TEES
Manufactured by cold working.
They are made from calendered and welded sheet metal.
They are the result of a joint between a cylinder and a welded branch.
Used in the construction of implants where it is necessary to make a lateral deviation on the main pipeline.
All products are marked.
BRANCH WELDED REDUCED TEE SPECIFIC
STAINLESS STEEL
1.4301/1.4307/304/304L
1.4401/1.4404/316/316L
*Other materials on request
EN 10253
168 – 1219
On request:
RX, penetrant liquids, heat treatment
Areas of application:
Industrial plants, Purification, Oil & Gas, Chemical, Petroleum
OUR PRODUCT
Branch Welded Tee and Reduced Tees
They are made from calendered and welded sheet metal
Welded Elbow
They are obtained from sheet metal, through the welding of two stamped shells
Pressed Collars
This type of product is obtained from sheet metal by means of deep cold forging